Sorry, this job is no longer accepting applications. See below for more jobs that match what you’re looking for!

Electronic System Control Craft Worker In Charge

Expired Job

Department Of Defense Umatilla , OR 97882

Posted 3 months ago

  • Videos

  • Duties

HelpDuties Summary

About the Position: This position is located at a hydro-electric generating facility that includes hydropower, navigation, fish passage and recreational activities. The project spans the Columbia River near the town of Umatilla OR, approximately 10 miles N. of Hermiston, OR and 30 miles S. of Kennewick, WA, which are full service communities. There is a daily van pool from the Tri-Cities. Employees working at McNary Dam and living in the State of Washington are exempt from Oregon state tax.

Learn more about this agency

Responsibilities

  • You will make recommendations for advance planning for crew work assignments, order materials necessary for the job, and mobilize resources needed to execute work assignmen

  • You will be responsible for scheduling equipment outages and coordinating work efforts with other crews and contractors.

  • You will provide verbal or written reports to higher level supervisors that describe the status of work assignments, causes of delay, and technical or personnel problems encountered while executing work assignments.

  • You will participate in job hazard analyses, request and hold safe clearances, and maintain a safe work environment for your crew.

Travel Required

Occasional travel

  • You may be expected to travel for this position.

Supervisory status

No

Promotion Potential
00

  • Job family (Series)
    2601 Miscellaneous Electronic Equipment Install and Maintenance

  • Requirements

HelpRequirements Conditions of Employment

  • Appointment may be subject to a suitability or fitness determination, as determined by a completed background investigation.

  • You must be able to obtain and/or maintain a valid state driver's license.

  • ?A pre-employment physical is required.

Qualifications

Who May Apply: Only applicants who meet one of the employment authority categories below are eligible to apply for this job. You will be asked to identify which category or categories you meet, and to provide documents which prove you meet the category or categories you selected. See Proof of Eligibility for an extensive list of document requirements for all employment authorities.

  • Current Department of Army Civilian Employees

  • Current Permanent Department of Defense (DOD) Civilian Employee (non-Army)

  • Interagency Career Transition Assistance Plan

  • Military Spouses, under Executive Order (E.O.) 13473

  • Non-Department of Defense (DoD) Transfer

  • Office of Personnel Management (OPM) Interchange Agreement Eligible

  • Priority Placement Program (PPP), Program S (Military Spouse) registrant

  • Reinstatement

  • Veterans Employment Opportunity Act (VEOA) of 1998

Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., Peace Corps, AmeriCorps) and other organizations (e.g., professional; philanthropic; religious; spiritual; community; student; social). You will receive credit for all qualifying experience, including volunteer experience.

There is no specific length of training or experience required. However, you must be able to demonstrate, through experience shown in your written application materials that you possess the sufficient knowledge, skills, and abilities to successfully perform the work of this position without more than normal supervision.

Minimum Qualifications (Screen Out Element): Ability to do the work of an ELECTRONIC SYSTEM CONTROL CRAFT WORKER IN CHARGE without more than normal supervision. I have the ability to perform common tasks associated with the repair and maintenance of electronic equipment. I have the ability to give verbal instructions as the nature of repairs, installation, or maintenance to be made, and can proceed to carry out the work in cleaning, making adjustments and/or repairs, calibration, and retest of equipment including various relays, meters, recorders, controllers, indicators, radio transmitters and receivers, oscillators and amplifiers, electronic relays and other electronic and communication equipment. This work was performed in an industrial setting. I work under normal supervision of a supervisor who observes tasks in progress and upon completion to make sure they are properly performed

  • Failure to meet this Screen Out Element will result in an ineligible rating.

  • Ability To Lead or Supervise

  • Ability To Use Hand and Power Tools

  • Electronics
  • Ingenuity (Ability To Suggest and Apply New Methods)

  • Knowledge of Equipment Assembly, Installation, Repair, etc.

  • Theory of Electronics

  • Trouble shooting (Electronic Equipment)

  • Use of Test Equipment: Electronics

  • Physical Effort: Work requires moderate physical effort: Lift and carry equipment and supplies weighing frequently up to, and occasionally over, 45 pounds. Work requires prolonged standing, walking, climbing, bending, stooping, twisting, pulling, pushing, and kneeling. A high degree of concentrated mental and visual attention is necessary to determine cause of trouble, plan and carry out corrective action, interpret complex drawings, and coordinate a high degree of manual dexterity with close visual attention for sustained periods. Must be able to distinguish colors.

  • Working Conditions: Work is performed in the powerhouse, other project structures, and outdoors. The employee is exposed to noise,extremes of heat or cold, heights, oils, greases, confined areas, dust, dirt, exposure to water hazards. May be exposed to odors, fumes and moving and/or energized equipment. May work with a variety of toxic or caustic materials. There is a possibility of cuts, burns, falls, and electrical shock. Must wear all appropriate safety #equipment and protective clothing, and successfully complete and maintain all occupational

health requirements.

Education


See if you are a match!

See how well your resume matches up to this job - upload your resume now.

Find your dream job anywhere
with the LiveCareer app.
Download the
LiveCareer app and find
your dream job anywhere
lc_ad

Boost your job search productivity with our
free Chrome Extension!

lc_apply_tool GET EXTENSION

Similar Jobs

Want to see jobs matched to your resume? Upload One Now! Remove
High Voltage Electrician

Department Of Energy

Posted 1 week ago

VIEW JOBS 12/4/2018 12:00:00 AM 2019-03-04T00:00 * Videos * Duties HelpDuties Summary This recruitment is an OPEN CONTINUOUS ANNOUNCEMENT (OCA) being utilized to fill current and future High Voltage Electrician (Maintenance) vacancies within BPA's Transmission Field Services Organization. Eligible applicants being placed on a standing register at the below cut-off dates: August 3, 2018 October 15, 2018 December 7, 2018 Please note: Not all locations will be pulled at every cut-off date. Please select all locations you would like to be considered for. Learn more about this agency Responsibilities There are several High Voltage Electrician (Maintenance) positions available with Bonneville Power Administration in different locations throughout Washington, Oregon, Idaho and Montana. A successful candidate in this position will perform installation and adjustment (construction) or maintenance and repair (maintenance) of electrical equipment in Substations. The construction aspects of a High Voltage Electrician task include erection of new facilities or removal of old facilities. The maintenance aspects include routine inspection, modification, troubleshooting, and repair of facilities. Equipment serviced may be electrical, hydraulic, mechanical, pneumatic, and/or electronic. High Voltage Electricians work from sketches, drawings, blueprints, wiring diagrams, and instruction books. Normally, a High Voltage Electrician will perform either construction or maintenance tasks. However, the employee may be required to perform any duty of the craft concerning electrical equipment in substations. The High Voltage Electrician usually reports to a High Voltage Electrician Foreman but occasionally may work independently. The High Voltage Electrician performs all duties in compliance with government regulations, BPA safety rules, and the BPA-CPTC Collective Agreement. As an Electrician you will: * Maintain and repair (maintenance) major electrical equipment in substations. When equipment fails, perform emergency repairs. * Perform diagnostic testing to inspect parts and equipment. * Perform work in shops on equipment components including bushings, motors, small power tools, etc. Assemble, install, and modify control and relay panels for substations. * Assemble and erect steel racks and towers to support equipment. * Install and change antennas, reflectors, transmitting or receiving devices, emergency power supplies, and other equipment located in microwave or radio stations. * Takes clearances and performs switching to isolate a piece of equipment for repair. * Conduit and trenches for equipment are installed under the service yard. Cables are pulled through the conduit. Complete associated documentation required of the above listed tasks. * Drive 20-50% of the time in all weather conditions. Travel Required 50% or less - Occasional Travel may be required. Supervisory status No Promotion Potential 00 * Job family (Series) 2810 High Voltage Electrician * Requirements HelpRequirements Conditions of Employment * You must be a United States Citizen. * This employer participates in the e-Verify program. * Males must abide by Selective Service registration requirements. * If exposed to health hazards, have periodic physical examinations as prescribed by competent medical authority at BPA expense. (Employees will work in close proximity to substances, such as lead, acids, solvents, or PCB's, which may have effects on health unless prescribed handling procedures are followed.) * Become fully knowledgeable of and follow the safety practices of the BPA Accident Prevention Manual. * Establish a residence in accordance with negotiated requirements, that is within one hour or less commuting time under normal weather and road conditions, to the duty station headquarters. * Possess within 1 year after appointment, and maintain continuously thereafter, a First Aid Card and a CPR card. * Possess a clearance certificate and an electrical worker's permit or obtain them within 1 year of appointment and maintain continuously thereafter. * Possess a valid state driver's license at the time of employment. Once employed the incumbent will also be required to provide proof of a valid commercial driver's license (CDL) with all endorsements that are required to operate substation maintenance and construction equipment from the state of residence within 120 days after appointment. Traffic citations indicating poor driving habits may disqualify applicants. * Be certified on aerial lift or other equipment if assigned to use or operate. * Take First Aid refresher training, when possible. * Subject to call for emergency work at any time. * Drive two and four-wheel drive vehicles, which may include towing various equipment trailers, normally used in substation maintenance and construction. * Be able to wear protective apparel such as respirators when required for worker safety. * During the first year, new hires will be required to successfully complete the Power System Electrician orientation training. This includes evaluating employees on both written and performance tests. Qualifications In order to qualify for this position, your resume must provide sufficient experience and/or education, knowledge, skills, and abilities, to perform the duties of the specific position for which you are being considered. Your resume is the key means we have for evaluating your skills, knowledge, and abilities, as they relate to this position. Therefore, we encourage you to submit a thorough resume that directly relates to this position. Applicants must meet the requirements of the Office of Personnel Management (OPM) Job Qualification System for Trades and Labor Occupations (X-118C). Although a specific length of time and experience is not required for most trade and labor occupations, you must show through experience and training that you possess the quality level of knowledge and skill necessary to perform the duties of the position at the level for which you are applying. Qualification requirements emphasis is on the quality of experience, not necessarily the length of time. Your qualifications will be evaluated on the basis of your level of knowledge, skills, abilities and/or competencies in the job elements and screen out listed below. This job has one screen-out factor which will be used to determine minimum eligibility for this job. Applicants who do not receive a minimum of two points on the screen-out element will be found ineligible. The screen-out element for the High Voltage Electrician, BB-2810-00 position is: Element 1: ABILITY TO PERFORM THE WORK OF A HIGH VOLTAGE ELECTRICIAN WITHOUT MORE THAN NORMAL SUPERVISION. (SCREEN-OUT ELEMENT. Failure to meet this requirement will result in an ineligible rating.) In addition to the screen-out element above, you will be evaluated on the following job elements through your resume and responses to the on-line assessment questionnaire: Element 2: Knowledge of Electrical Equipment Element 3: Theory and Instruments (Electrical) Used in Shop and Trade Practices Element 4: Technical Practices (theoretical, precise, and artistic) Element 5: Ability to Use Electrical Drawings Element 6: Ability to Use and Maintain Hand Tools (Electrical Work) Element 7: Troubleshooting (Electrical) Element 8: Knowledge of Safety "Experience" refers to paid and unpaid experience. Examples of qualifying unpaid experience may include: volunteer work done through National Service programs (such as Peace Corps and AmeriCorps); as well as work for other community-based philanthropic and social organizations. Volunteer work helps build critical competencies, knowledge, and skills; and can provide valuable training and experience that translates directly to paid employment. You will receive credit for all qualifying experience, including volunteer experience. Working Conditions: Working conditions vary depending on tasks. Most work is performed outside in all weather conditions, but some work is done inside under normal shop conditions. Work is performed around energized equipment, such as switchboards containing critical control circuits where carelessness could cause a serious system disturbance or outage. Work is done in energized Substations at various heights in excess of 100 feet, such as on steel framework, platforms, and ladders adjacent to energized high-voltage equipment. The Electrician must frequently work on surfaces which are slippery due to insulating oil or ice. Installing conduit, pulling cable, working in oil circuit breaker (OCB) tanks, etc., involves working in restricted and cramped quarters. Approved respiratory and safety equipment shall be worn when hazardous substances are being handled (oil, acid, and solvent fumes, etc.). At times, work may be physically demanding. The work environment will occasionally include high noise levels or exposure to hazardous substances (i.e., mercury, acids, solvents, PCB's, etc.) that could, if precautions are not followed, pose a health risk. Potential exposure to radiation could occur if assigned to work at the WNP2 plant (Ashe and Hanford). Emergencies, critical system conditions, or outage limitations may require that work be system wide, done at night or under serious time pressures. System priorities may require extended periods of overtime including working weekends and holidays. When assigned to Construction the Electrician may be in continuous travel status. Note: Applicants must possess at appointment, and maintain thereafter, a valid U.S. State issued Motor Vehicle Operator License (Driver's License) in order to drive and operate U.S. government owned and leased vehicles and equipment. If selected, you will be required to provide a copy of your non-employment driving abstract dated within the last 90 days, and covering the previous 36 months to prove you have good indication of driving. Traffic citations indicating poor driving habits may disqualify applicants. Once employed the incumbent will also be required to provide proof of a valid commercial driver's license (CDL) with all endorsements that are required to operate substation maintenance and construction equipment from the state of residence within 120 days after appointment Time-in-Grade: Current Federal employees must meet time-in-grade requirements by the closing date of this announcement to receive consideration. CTAP/ICTAP candidates: To be considered "well qualified" you must meet all of the requirements as described in this section. You must meet all qualifications and eligibility requirements by the closing date of this announcement. Education This position does not have a positive education requirement; however, if you are using completed education or training to support your meeting the qualifications or other requirements for this position, you must submit documentation of education received that relates to this position. Education must be obtained from an accredited institution recognized by the U.S. Department of Education. Foreign education must be reviewed by an organization recognized by the U.S. Department of Education. For special instructions pertaining to foreign education and a list of organizations that can evaluate foreign education, see the Department of Education website. Department Of Energy Umatilla OR

Electronic System Control Craft Worker In Charge

Expired Job

Department Of Defense